Fast Setting, High Performance Polymer Composite Floor Protection System
ENECLAD FSC is a water-based, two-component coating system that has been specifically designed to seal and protect concrete surfaces that need to return to service quickly.
ENECLAD FSC is a fast setting coating which will minimize downtime. It bonds to virtually any mineral / cement substrate as well as wood.
Foot traffic in as little as 90 minutes!
- Excellent Abrasion & Impact Resistance
- Outstanding Adhesion
- Safe & Simple to Use
- Ideal for protecting concrete floors when moisture is present
Also Available in Safety Yellow
Technical Data
- Theoretical coverage rate per kg.
@ 10-12 mils - 25 ft2 / 2.5 m2
| Mixing ratio | Base | Activator |
|---|---|---|
| By Volume | 4 | 3 |
| By Weight | 1 | 1 |
| Ambient Temperature | Working Life | Minimum Overcoating | Maximum Overcoat | |
|---|---|---|---|---|
| 59°F | 15°C | 30 min. | 4 hrs. | 24 hrs. |
| 77°F | 25°C | 20 min. | 2 hrs. | 12 hrs. |
| 86°F | 30°C | 15 min. | 1 hr. | 8 hrs. |
Colors
Gray
Haze Gray
Safety Yellow
Note: Other colors are available on a “special order” basis. However, there are minimum / multiple quantity requirements for such orders and there may be an increase in cost. Additionally, due to formulation restrictions, not all colors are possible for all materials. Speak to your local ENECON Sales Representative for more information.
Due to monitor / printer differences, actual colors may vary slightly from the representations appearing in this chart.
Working Life & Cure Times
| Ambient Temperature | Foot Traffic | Fork Lift | Full Cure | |
|---|---|---|---|---|
| 68°F | 20°C | 3 hrs. | 8 hrs. | 3 days |
| 77°F | 25°C | 2 hrs. | 6 hrs. | 2 days |
| 86°F | 30°C | 1.5 hrs. | 5 hrs. | 1 day |
Chemical Resistance
| Gasoline | EX | Detergent Solution | EX |
| Kerosene | EX | Trisodium Phosphate | EX |
| 50% Anti-Freeze | EX | 20% Calcium Chloride | EX |
| Transmission Fluid | EX | 10% Hydrochloric Acid | EX |
| Power Steering Fluid | EX | 10% Sulfuric Acid | EX |
| Motor Oil | EX | 10% Sodium Hydroxide | EX |
EX - Suitable for most applications including immersion
G - Suitable for intermittent contact, splashes, etc.
